USA news on Youtube Nov 10 2017

TDCSH today we will teach you to do famous capsules capsule corp

With different colored labels

And a button that you can press as authentic

Moreover, these capsules have a compartment secret

Where you can hide some things

Learn to manufacture capsules bulma

Today TDCSH

The first thing we need is 2 marbles this type

They are large

We also need a cylinder a little more small marbles

We use a candle

This cylinder roll up a strip of cardboard 1 cm wide

Pasting with glue stick to is securely closed

But stick to the cylinder

What we want is to make a cardboard tube

Many will stick cardboard strips as they are necessary

To get our tube is almost as wide as the marble

Then we will draw the cylinder tube

And will the marble top

Missing turns for the tube to be so wide as the canica

We will give a media strip paper centimeter wider

This paper tube is glued to cardboard

And stands only on one side

We will continue strips of paper until the tube is the same width as the marble

Stick the tube to the marble with hot silicone in this way

To remove the cut between the marble and tube

We based putty flour and cola

Mix until a paste as this

And we applied at the junction between the canica and the role

Filling the cut

When we have completely covered

And before the paste dries

I smoothed with wet finger in water

Once a smooth let dry a few hours

Dry while we repeat all steps

But with a card of 3 cm width

We tube

Then the paper

We hit the other canica

We put the dough and let it dry

When the pasta is completely dry

And if we have some imperfection

We can smooth with fine sandpaper

So we should be

After we use another cylinder that fits within Tube first marble

It has to be a little smaller than the hole

Above this other tube will

This time of 2 cm wide

You have to fit within the other

But not too tight

For the last few laps we will give tape

One end of this tube crush him a bit

To enter into this piece easily but tight

The other extreme will stick within the another piece

With instant adhesive

To the bottom

Also apply adhesive to the edge the large piece

To harden cardboard

That done, we can paint the big piece

Coated white spray

And if you do not have you can use nail polish

Before painting the small piece

We will make another tube using as template a round marker

And a paper strip half a centimeter

When we do we will cover adhesive to strengthen

Careful not stick to bookmark

This tube paste it on top the first canica

And very well centered

With instant adhesive

we can paint this piece

But this part unpainted

To protect the cover with tape or paper

We need to make the button ... a button

One centimeter in diameter more or less

This stick around another strip of paper half centimeter wide

So it is flush button by a expensive

And all the surplus left by the other

On this side we stick the paper button

On the flip side we stick a piece of paper

And we cut to give shape

We need for the spring mechanism a pen

With a paper strip 8 mm

Formed around another tube

And another just above the first but stick to the

So

Insert the small tube half in of the other

We dock single small tube

And we cut what stands out the large tube

Apply silicone to the button face that no paper

Well centered and paste the dock by the end we cut

well straight

Then paste it into the same place the small tube

In this way

The button is ready to paint

So we are left with two pieces painted

And so the button

Now we can put the tube Button inside big

Situating the latter spring flush

We hit the button in the center of this ring

With a drop of adhesive

I focus very well and press a little so that the spring sticking

Then press the outer tube to Also sticking

We already have ready our mechanism

I have left in the video description templates labels

You can choose which one you like best

The recortáis and pegáis on a piece of cardboard

To be more resistant

We close the capsule

And stick the label with glue stick in the middle

Thus clog the cut between the two parts

But only we stick to the bottom piece

The above is the plug

The label will cut a piece tape inside

We cut the excess with scissors

And we will have completed our capsule

This capsule is perfect for storing bulma some savings

To hide some of our jewels

Or whatever you want

In addition to the button it works perfectly

And if you want a larger cache only you have to use a larger balls

Leave a like if you like and share video on your social networks

Build a replica capsules capsule corp

To add to your collection of Dragon Ball

And check our videos channel see more tutorials in this legendary series

For more infomation >> Bulma's Capsule Corp capsules - DRAGON BALL - Duration: 10:05.

-------------------------------------------

Top 15 Uses of Alum for face, skin, and health - Benefits of Alum Fitkari powder - Duration: 8:13.

Top 15 Uses of Alum for face, skin, and health - Benefits of Alum Fitkari powder

Alum, standard referred to as Fitkari, may be a ordinarily used name of chemical compound:

the atomic number 19 double salt of metal.

Alum is documented for water purification, once shave treatment and preventing evil influences.

Alum powder is employed in an exceedingly wide selection of applications from deodorants

through to creating pickles because it is capable of inhibiting microorganism growth.

Alum powder is employed in animal skin tanning, dyeing, leavening and fireproof textiles.

Alum encompasses a ton of medical and health edges.

however we want to create certain that solely a pinch is employed once taken internally.

Also, it's counseled to not use alum outwardly on skin on daily.

Larger intake of alum has negative facet effects for the health.

therefore it's vital to stay the alum stone and alum powder far from kids.

1) Alum for Evil Eye and prevention of evil influences:

In Tamil Nadu, Alum stone(padikara kal) is one among the things accustomed forestall

USA from looking at and evil influences.

it's a protracted term belief and being followed by generations.

individuals sometimes tie it mistreatment black rope and droop the alum stone outside

the house to stay the evil influences away.

2) Alum Stone / Alum Block for shaving cuts: Alum stone is commonly used for after shaving

treatment.

It is used a styptic for minor bleeding from shaving cuts.

3) Alum stone/block and powder for deodorant for body odor:

Alum is used as a natural deodorant for body odor as it has the capability of inhibiting

bacterial growth which is responsible for body odor.

But people say that it is not recommended to use it everyday.

4) Alum block for minor bleeding: Alum is used to treat minor bleeding resulting

from minor cuts and abrasions.

Sprinkling alum powder can help to stop bleeding.

However deep cuts and non stop bleeding requires medical intervention.

5) Alum(Potassium Alum) for Water Purification process:

Alum is used in water purification treatment widely.

Alum attracts fine particles and suspended materials in raw water.

It settles down those particles at the bottom of the water.

The water over those particles are clean other than the dissolved particles.

Hence alum powder is widely used in purifying muddy water when people go for camping.

Add 5 mg alum powder per liter of water.

Check whether it is able to clean the water.

If not, add pinch by pinch.

Make sure that you do not add more alum powder as it can cause negative side effects like

nausea, vomiting, stomach upsets and many more when taken internally.

6) Alum for canker sores: Alum powder is used to treat canker sores

easily.

Just place a pinch of alum powder on top of the sore and leave it for 30 seconds.

Wash it off thoroughly.

Repeat this for 2-3 times daily till the canker sores go off.

You will get complete cure mostly within 3 days.

7) Alum for acne/pimples and tightening: Alum is used for pimples, acne marks, acne

scars and acne treatment widely.

Alum powder is widely used for treating acne and pimple problems.

Let us see how to use alum powder for acne.

Mix alum powder with water and apply it on the acne.

Leave it for 20 minutes and wash the face with clean water.

Regular usage of alum powder reduces the acne.

Alum is used for tightening the skin too.

You can use rose water instead of water.

You can also add egg whites if you like the egg white smell.

8) Alum for athlete's foot: Alum powder is one of the home remedy to treat

athlete's foot.

Add 2-3 tbsp of alum powder in hot water and soak the feet in the water till the water

remains hot or warm.

Soak for a minimum of 20 minutes.

Dry the feet and do not wear any synthetic fabrics till the athlete's foot is cured.

Repeat this daily to get rid of athlete's foot quickly.

9) Alum for hair removal: Alum is widely used for hair removal.

Women in ancient ages used alum for removing unwanted facial hairs like upper lip hair.

Mix 1/2 tsp of alum powder with 1 tsp of rose water and keep it ready.

Adjust the quantity of alum powder and water as required.

The ratio of alum powder to rose water is 1:2 approximately.

Once hair is removed or waxing is done, apply the alum mixture on the face or the place

where you want the facial hairs to be removed.

Leave it for 20 minutes.

If you feel that the mixture gets dried up, you can sprinkle rose water on it to keep

it on more time.

Wash thoroughly and pat the face dry.

You can do this on your hands and legs too.

Apply moisturizer after pat drying to keep the area moisturized.

Regular coconut oil can be used for moisturizing.

Take care not to apply on the eye and surrounding areas.

You can do this process after you go through hair removal process like threading and waxing.

It will slow down the hair growth.

Follow the process for long time to see the visible results like 6 months to 1 year.

9) Alum for hair removal: Alum is widely used for hair removal.

Women in ancient ages used alum for removing unwanted facial hairs like upper lip hair.

Mix 1/2 tsp of alum powder with 1 tsp of rose water and keep it ready.

Adjust the quantity of alum powder and water as required.

The ratio of alum powder to rose water is 1:2 approximately.

Once hair is removed or waxing is done, apply the alum mixture on the face or the place

where you want the facial hairs to be removed.

Leave it for 20 minutes.

If you feel that the mixture gets dried up, you can sprinkle rose water on it to keep

it on more time.

Wash thoroughly and pat the face dry.

You can do this on your hands and legs too.

Apply moisturizer after pat drying to keep the area moisturized.

Regular coconut oil can be used for moisturizing.

Take care not to apply on the eye and surrounding areas.

You can do this process after you go through hair removal process like threading and waxing.

It will slow down the hair growth.

Follow the process for long time to see the visible results like 6 months to 1 year.

11) Alum for black or dark underarms: Using deodorant for long time might be one

of the causes of black underarms or dark underarms.

Using alum powder as deodorant can help to get rid of black underarm problem.

But do not use it daily.

12) Alum for cold sores: Add a drop of water to a pinch of alum powder

and apply it on the cold sore.

Leave it for 30 seconds and wash it off thoroughly.

Repeat this process twice or thrice daily to see the visible results within 3 days.

13) Alum for cooking and canning: Nowadays you get cooking alum(alum exclusively

for cooking purpose) in many Indian grocery stores.

It is used in making pickles to maintain the crispiness of fruits and vegetables used in

the pickles.

Alum powder is also used in making baking powders as an acidic component.

14) Alum for dandruff: A pinch of alum powder and salt are added

in shampoo while taking head bath to reduce the dandruff and to treat itchy scalp.

Take care not to add more alum.

15) Alum for dark circles: Many commercial brands started using alum

powder in their product for curing dark circles.

You can mix a pinch of alum powder with water and apply it on the dark circles.

Take care not to apply on the eye.

Please do it carefully.