Use a 12-point socket ı32. Loosen and remove the hub nut.
Use a drive socket No.17. Use a ratchet wrench. Unscrew the brake caliper fastening
Use a drive socket No.17. Use a ratchet wrench. Unscrew the end fastening nut to the steering knuckle.
Use a combination spanner No.19. Remove the nut of the lower ball joint bolt.
Use a ball joint remover. Using a special tool push the steering rod end out of the steering knuckle.
Use a combination spanner No.17. Use a drive socket No.17 . Unscrew the lower fastener of the shock absorber strut.
Remove the steering knuckle together with the hub.
Use a flat screwdriver. Remove the inner wheel bearing oil seal.
Install the steering knuckle in the wheel arch and pass the drive shaft through the hub center.
Connect the ball joint of the control arm to the steering knuckle and install the ball joint fastening bolt.
Tighten the lower fastening of the shock absorber. Use a combination spanner No.17. Use a drive socket No.17 .
Screw the hub nut. Use a 12-point socket ı32.
Install the brake caliper and fix it. Use a drive socket No.17. Use a ratchet wrench.
Connect the tie rod end to the steering knuckle and tighten it. Use a drive socket No.17. Use a ratchet wrench.
No comments:
Post a Comment