Hello!
In their products I often use the link on pocket hole
Today I want to talk about the original fixture for this connection
This Kreg jig pocket hole
And in talking about the connection pocket hole
people often say that it is not very aesthetically pleasing, and connection.
And I want to tell you about the second device
which allows to make
special plugs to hide the holes for the screws
Now let's look at each of them in more detail
In this set of fixtures
goes device
clamping
Well, the kit of screws and plugs
I took this set for action
its advantage is that in the kit there is a clamp, and more expensive set
not significant.
So the clamp goes
practically free.
The device comes in a case which is
the conductor, a wrench and a drill also the case is immediately line and can
to set the depth of drilling through it.
Unfortunately the scale for depth setting drilling
written in inches and for me it is unusually.
But there is a sign
translation of centimeters to inches.
I have prepared workpiece 2 cm,
and this is 3/4 of an inch.
on themselves the conductor I also set 3/4
The conductor has a special device to stick in there
clamp and fix the workpiece
but since I have a mobile table Kreg
can I use a member set it to clamp clamp
now install a drill bit and drill hole
Good drill, it drills very quickly, in one setting.
It is not necessary several times to pass back and forth drill
Get these here holes.
I'll be joining the blanks here.
For this I again will clamp them on your table
Comes with a special bit.
Special it is because it has
a square section of the tip because the screws are an American slot square.
Now connect the two billets.
Such a connection is obtained.
I think its strong and reliable
And very fast.
I even tested
the strength of this connection. There is separate video on this topic
It so happens that the connection is oblique screw you need to produce from
the front of the product.
It's not very aesthetically pleasing, therefore, the bundle of plugs
who put glue in the hole,
well and, accordingly, superfluous barked
in level with the product.
But set total 4 pieces
so now I will tell you about the device which allows to make these
plugs in unlimited quantities.
Such a conductor.
is not a normal drill bit
and the terminator of depth of drilling
with the help of it now I will make your own plugs
Also note the jig on the workpiece
and start drilling
the instructions now had to be cut off an angle of 15 degrees
now it only remains to put these caps on glue
and as the drying
to make sanding.
And in order to to hide imperfections even better,
it is possible for the adhesive sprinkle a little sawdust
and when sanding is virtually invisible seam
two different old crop, but the manufacture of the product, of course you need
to use the same material and then it will be almost imperceptible connection
I hope you it was interesting learn about these devices
most have never used plugs, but he knew that there is a special device for them
and so very wanted try. so now I plan
actively use it in their work.
Thank you all for watching and bye!
No comments:
Post a Comment